Micelect - Lm3d Manual

Configurable for Presence (Anti-nuisance), Full Load (80%), and Overload (100%).

Run the 14-foot connecting cable (or longer versions) from the sensor to the LM3D control unit in the machine room.

Manually entering the sensor's capacity or performing an automatic calibration. micelect lm3d manual

Often caused by "Optical Noise." Clean the lens with a soft, lint-free cloth and isopropyl alcohol.

The LM3D unit is standardly built for DIN rail mounting or can be housed in an IP-65 rated box. 230 VAC (also available in 115 VAC models). Alarm Relays: Three programmable relays (250 VAC, 3A). Alarm 3: Typically assigned to Overload (100% capacity). Alarm 2: Often used for Full Load (e.g., 80% capacity). Often caused by "Optical Noise

Use the buttons to cycle through parameters such as sensor type, calibration values, and alarm thresholds.

: Connect a signal (24-230V AC/DC) that is active while the car is moving to freeze weight values. Zeroing (Tare) : Perform a zero setting with an empty cabin. Alarm Relays: Three programmable relays (250 VAC, 3A)

The LM3D facilitates a "TARE" (zeroing the empty car weight). According to Kone KDL16 maintenance instructions (which detail using Micelect LWDs), the programming procedure is as follows:

5V, 0-5V), RS485 data communications, pre-opening doors software, and rollback control mechanisms. Step-by-Step Installation Procedure

The MiElect LM3D is covered by a one-year limited warranty. For technical support, please visit our website or contact our customer support team.