Ensure the bypass valves are in the correct position. Check that the unit has salt and that a "salt bridge" (hardened crust of salt) hasn't formed, blocking water contact.
Check that the drain hose is not blocked or kinked. Conclusion
Make sure to use WRAS approved flexible hoses to ensure your installation complies with local water regulations.
Connect the to the waste outlet and run it to a drain with a minimum 20mm air gap to prevent back-siphoning.
Slowly open the and close the Bypass Valve . The home is now supplied through the water softener. Initial Testing and Salt Loading harvey hv3 water softener installation manual free
Instead, let me give you a straightforward, helpful answer:
For a detailed visual guide, installers often refer to the Harvey Water Softener Installation Video or various block salt softener manuals .
Must be installed after the main water shut-off valve but before the plumbing splits into cold and hot water lines.
This comprehensive guide serves as a manual to help you navigate the installation process, from site selection to the final commissioning of the unit. Pre-Installation Requirements Ensure the bypass valves are in the correct position
Ideally installed on a firm, level surface near the main water supply.
: Run a drain hose from the softener to an upstand or outside drain. Ensure a minimum 20mm air gap at the end of the drain to prevent siphoning. Set Up Overflows
Following the general guidelines for block salt softeners, here is the typical installation sequence: Step 1: Isolate the Water Supply
Once all plumbing connections are secured, follow these steps to pressurize and test the system. Conclusion Make sure to use WRAS approved flexible
Remember, the HV3 is non-electric; it counts the gallons used mechanically. If you experience hard water, check for salt bridging or ensure the bypass valves are in the correct "open" position.
Directs outgoing soft water into the home plumbing. Bypass Valve: Connects the inlet and outlet pipes directly. Valve Configurations
Tip: Use flexible hoses to make connecting easier and to reduce noise transmission. Step 4: Connect the Drain Line
Ability to run an overflow pipe to the outside. 2. Step-by-Step Harvey HV3 Installation Guide Step 1: Turn Off the Water