Once the upgrade screen disappears and the process is complete, shut down and restart the oscilloscope. Method 2: Advanced/Reverse-Engineered Firmware Update
Now, plug the USB data cable into your DSO2512G and into your computer. Once connected, a new disk drive, labeled as a "Udisk" (USB disk), should appear on your computer. This is not the device's internal memory but a virtual drive for the firmware update.
The update process took a few minutes, during which the oscilloscope's display flickered and the device restarted several times. John anxiously waited, hoping that the update would be successful. dso2512g firmware install
If the USB drive does not appear, try a different USB cable or USB port on your computer.
In the settings grid, check and select "Reset and Run" if available. Step 4: Flash the Firmware Click the "Start Programming" button in FlyMcu. Once the upgrade screen disappears and the process
: Ensure your DSO2512G has at least a 50% charge.
Press and hold a specific button (usually the or [Menu] button, refer to your specific version's manual) while turning the device on via the power switch. This is not the device's internal memory but
Extract the contents to a folder on your computer. You should see a .bin or .app file. Step 2: Put the DSO2512G into Bootloader Mode
disconnect the cable until the screen indicates the update is complete. Method 2: Advanced Serial/FEL Mode (For Unresponsive Units)