Caraflo V200 Shower Instructions Jun 2026

: The opposite knob features an integrated safety override button set at 38°C .

Place the decorative chrome concealing plates (shrouds) over the supply pipes.

Using the Caraflo V200 for a normal shower is straightforward. However, because it is a thermostatic valve, there are a few things to keep in mind.

Flush out the water lines prior to mounting to prevent debris from logging into the new cartridge. Step-by-Step Mounting V200 Caravan Shower Mixer Valve 45mm Centres Caraflo caraflo v200 shower instructions

Loosen the internal plug to let trapped water escape freely from the internal thermostatic cartridge chambers.

Place the temperature knob loosely back onto the splined brass spindle. If too cold: Turn the spindle slightly counter-clockwise. If too hot: Turn the spindle slightly clockwise.

Open all drain-down valves on the underside of your caravan chassis to evacuate remaining water from the shower supply lines. Troubleshooting Common Issues Potential Cause Inlets are reversed or supply is blocked : The opposite knob features an integrated safety

Unscrew the mixer body from the 45mm wall tails. Clean out debris caught in the mesh washers. Imbalanced static water pressure or failing cartridge.

Connect the water supply to the inlet marked "C" or labeled with a blue sticker.

Turn the thermostat valve fully clockwise to drain the cold side. However, because it is a thermostatic valve, there

Insert the specialized Caraflo drain-down key (included with the valve pack) into the drainage point to release trapped water. If a key is not present, loosen the main rear compression nuts using an adjustable wrench to break the seal, allowing the water trapped inside the cartridge chambers to cascade down the shower wall safely.

Some models allow for adjusting the flow rate by lifting the lever higher.

Important : The maximum mixed water temperature should never exceed 46°C.